Instructions for useGBEN
The electrical connections must comply with current legislation and be made by a suitably qualified professional. • Information on the voltage and po
Note: Refer to the table on page 6 to ensure that thecorrect type of injector is fitted.Traditional burners (T)1. Remove the cap (A).2. Remove the bur
The minimum flow level is regulated using the tap at the lowest posi-tion (small flame) .There is no need to regulate the primary air in the burners.T
Disconnect the hob from power supply andwait until it is cold before carrying outcleaning and/or maintenance work.To keep the hob in perfect condition
If the hob is not working properly, work throughthis guide before contacting our Customer CareCentre.Problem: The burner does not ignite or theflame i
400010887981Printed in Italyn06/16Whirlpool Europe S.r.l. – Socio UnicoViale G. Borghi, 27 – 21025 Comerio (VA)Phone +39 0332 759111 – Fax +39 0332 75
Product description and symbols 4Control symbols 4Using the burners 4Practical advice on using the hob 5Positioning the pan supports and wok support 5
1. Removable pan supports2. Auxiliary burner3. Semi-rapid burner4. Semi-rapid burner5. Professional wok burner6. Auxiliary burner control knob7. Semi-
Read these instructions to get the best out ofyour hob.- Use pans with a similar diameter to the burner(see the table on this page)- Use flat-bottomed
If a hood will be installed over the hob, refer to the hood installation instructions to ensure that the cor-rect clearance above the hob is maintaine
To get the most out of your hob, please readthese instructions carefully and keep them forfuture reference.• These instructions are only valid in cou
PackagingThe packaging materials are fully recyclable andmarked with the recycling symbol . Pleasedispose of all packaging responsibly and carefully.
Technical information for the installer• This appliance can be built into a worktop thatis 20–40 mm thick.• If an oven is not being installed below
Comments to this Manuals