KitchenAid KHRT 6020 Instruction for Use Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
Maintenance
Use protective gloves.
Disconnect the appliance from the power supply.
IMPORTANT: After carrying out hood or filter cleaning, refit the front panel and filters,
checking correct installation and hooking, otherwise the hood will not switch on.
GREASE FILTER
Its purpose is to retain the particles of grease produced by cooking.
It must be cleaned once a month (or when the filter saturation warning
system indicates this need) with non-aggressive detergents, by hand or in a
dishwasher at low temperature and with short cycle.
Cleaning in a dishwasher may cause discolouring of the metallic grease filter,
but its filtering efficiency is unaffected.
Grease and carbon filter fitting and removal is carried out with the hood
extraction panel in the open position. For this, press the ON button (T5).
Then remove the front panel by pressing the upper part of each side at the
same time. The panel pivots forward, freeing the access to the grease filters.
(Figure 5)
ACTIVATED CARBON FILTER (Filter Version only)
Its purpose is to retain the unpleasant odours produced by
cooking.
The carbon filter becomes saturated after more or less prolonged use
depending on the type of cooker and how often the grease filter is
cleaned. In any case the carbon filter must be replaced at least every four
months.
The carbon filter CANNOT be washed or regenerated.
The carbon filters can be inserted after removing the grease filters.
(Figure 6)
LIGHTING SYSTEM
Disconnect the appliance from the power supply.
IMPORTANT: Do not touch the neon with bare hands after prolonged
hood use with the lights switched on.
To replace the neon, proceed as follows (Figure 7):
1. Lift the extraction panel.
2. Disconnect the power supply (this operation can be carried out by
pulling out the plug, if accessible, or opening the switch, if provided for
during installation, or pressing the red reset button in the control box).
3. Remove the screws fixing the upper front.
4. Lift the upper front
5. Remove the burnt-out neon and replace it with one having the same
characteristics (Model T5 14W 860).
If the lighting does not work, make sure the neon is properly fitted before calling the After-Sales Service.
WARNING
WARNING
Fig. 5
Fig. 6
Fig. 7
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments