KitchenAid KHTD2 38510 Instruction for Use download pdf (Page 12)

Before connecting to the electricity supply, ensure that:

- the characteristics of the system are such as to satisfy that indicated on the registration plate applied to

the bottom of the hob;

- the system has an effective earth connection compliant with the standards and laws in force.

Connection to earth is compulsory by law.

If the appliance has no cable and/or plug, use material suitable for the absorption indicated on the

registration plate and for the working temperature. The cable must not reach a temperature higher than

50°C above room temperature in any point.

For direct connection to the network it is necessary to fit an omnipolar switch of a suitable size to ensure

disconnection of he network with a contact opening distance that allows complete disconnection in the

conditions of the overtension category III, compliant with the installation regulations (the yellow/green

earth wire must not be interrupted).

The omnipolar socket or switch must be easy to reach when the appliance is installed.

N.B.:

- The manufacturer declines all responsibility if the usual accident prevention standards and the above

instructions are not observed.

If the power cable is damaged, it must be replaced by the manufacturer or by the manufacturer’s technical

servicing network, or by a similarly qualified operator, to prevent every possible risk.

Connection to the terminal block

For the electrical connection, use an H05RR-F or H05 VV-F cable as specified in the table below.

Electrical connection

~ V032

L N

H05 RR–F 3x1.5

H05 VV–F 3x1.5

Wires Number x size

220-240 V ~ +

3 x 1,5 mm

Instructions for use

Installation

All installation operations (electrical connection) must be carried out by people qualified in compliance

with the laws in force.

For specific instructions, see the installation section.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

KitchenAid KHTD2 38510 Instruction for Use Page 12