KitchenAid ADP 4570 IX Instruction for Use Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
6
Reference guide
1. PROGRAMS SELECTION BUTTON
Push “P” button (repeatedly) until selected program number is shown on the display (P1...Px) see “Table of
programs” below.
2. CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the program ongoing draining water for 1 minute (0:01 is
shown into the display).
If pressed when the dishwasher is switched off, it drains any possible liquids from dishwasher (1 minute
process).
3. START/RESUME BUTTON
Push this button to start the selected program: the indicator lights up and goes off at the end of the program.
When the door is opened during a washing cycle, the cycle is temporarily paused: the Start indicator blinks.
To resume the cycle close the door and push Start button again.
Table of programs
Detergent
Consumption
Drying
Phase
Programs
Loading instructions
Available
options
Litres kWh Minutes
1)
P1
Sensor 40-70°C
Recommended program for routine
washes, with dried-on food.
Delay
Hygiene
1/2 Load
X 7-15 1.00-1.70 70-172 Full
P2
Pre-Wash cold
Crockery to be washed later. Delay
4.0 0.01 14-16 NO
P3
Rapid 45°C
Lightly soiled crockery, with no
driedon food.
Delay
X 11.0 0.85 30-50 NO
P4
Eco
2)
50°C
Normally soiled crockery.
Standard program, the most efficient
in terms of its combined energy and
water consumption.
Delay
Hygiene
1/2 Load
X 10.0 0.922 230 Full
P5
Daily 60°C
Normally to heavily soiled crockery.
Delay
Hygiene
1/2 Load
X 11.0 1.30 80-95 Full
P6
Steam
Program including steam action
dedicated for heavily soiled crocery,
pots and pans. Soaking or hand
pretreatment is no longer needed.
Delay
Hygiene
X 14.5 1.75 180-190 Full
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may
vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic
calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
Power consumption in Left-on mode: 1.50 W / Off-mode: 0.50 W
Page view 3
1 2 3 4 5 ... 17

Comments to this Manuals

No comments