KitchenAid KHGD4 60510 Instruction for Use download pdf (Page 12)

Regulating the minimum flow level must be done with the tap at the

lowest position (small flame) .

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the

control knob and adjust the screws found on the tap as follows:

1. tighten to reduce the height of the flame 1 (-)

2. slacken to increase the height of the flame (+);

3. With the burners on, rotate the buttons from the maximum to

the minimum position to check the stability of the flame.

Once you have finished regulating, close up the seals again using

sealing wax.

Regulating the minimum flow level of the gas taps

To replace the injectors in special burner it is necessary to:

1. Remove spreader (C), the screws (B) holding the cover cap (A)

and the cap itself.

2. Unscrew the inner injector (D) and the outer injector (E) with a

box spanner 7.

3. Replace the injectors.

4. Put back the cover cap, screws and spreader.

Note: make sure that:

1. After replacement the spreader (C) is inserted correctly on the

burner.

Injectors replacement in the wok burner

D E

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

KitchenAid KHGD4 60510 Instruction for Use Page 12