INSTALLATION INSTRUCTIONS 30" (76.2 CM)FREESTANDING ELECTRIC RANGE WITH DOUBLE OVENSRANGE SAFETYTable of ContentsRANGE SAFETY ...
102. Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex nuts.3. Connect line 1 (
114. Attach terminal lugs to line 1 (black), neutral (white), and line 2 (red) wires. Loosen (do not remove) the setscrew on the front of the terminal
123. Use ³⁄₈" nut driver to connect the bare (green) ground wire to the center terminal block post with one of the 10-32 hex nuts.4. Connect line
13Moving the RangeWhen moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.If removing the range is necessary f
15Notes
W10694065A®/™ ©2014 All rights reserved.9/14Printed in U.S.A.
2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w
3Product Dimensions*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. **Model/serial/rating plates may be rotated up
4Electrical RequirementsIf codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the
5INSTALLATION INSTRUCTIONSUnpack Range1. Remove shipping materials, tape and film from the range. Keep cardboard bottom under range.2. Remove oven rac
6Install Anti-Tip Bracket1. Remove the anti-tip bracket that is taped inside the upper oven with the package containing literature.2. Determine which
7Electrical Connection1. Disconnect power.2. Use Phillips screwdriver to remove the terminal block cover screw located on the back of the range. Pull
8Style 2: Direct wire strain relief Use Phillips screwdriver to remove screws and slide cord/conduit plate down and out. Position cord/conduit plate
94-wire Connection: Power Supply CordUse this method for: New branch-circuit installations (1996 NEC) Mobile homes Recreational vehicles In an ar
Comments to this Manuals