KitchenAid KGCD807XBL Instruction Manual download pdf (Page 11)

Typical flexible connection.

4. Install the pressure regulator with the arrow pointing up

toward the bottom of the cooktop base and in a position

where you can reach the regulator access cap.

IMPORTANT: All connections must be wrench-tightened. Do

not make connections to the gas regulator too tight. Making

the connections too tight may crack the regulator and cause

a gas leak. Do not allow the regulator to turn on the pipe

when tightening fittings.

Use only pipe-joint compound made for use with Natural and LP

gas.

Do not use TEFLON

tape. You will need to determine the fittings

required depending on your installation.

Complete Connection

1. Open the manual shutoff valve in the gas supply line. The

valve is open when the handle is parallel to the gas pipe.

2. Test all connections by brushing on an approved

noncorrosive leak-detection solution. If bubbles appear, a

leak is indicated. Correct any leak found.

3. Remove surface burner caps and grates from parts package.

Align notches in burner caps with pins in burner base. Burner

caps should be level when properly positioned. If burner caps

are not properly positioned, surface burners will not light.

Place burner grates over burners and caps.

4. Plug into a grounded 3 prong outlet.

Electronic Ignition System

Initial lighting and gas flame adjustments

This cooktop is equipped for electronic auto-reignition by means

of a spark igniter located at the rear of each burner. The burners

are designed to light at any valve rotation that admits sufficient

gas flow to support a flame and to automatically relight following

a loss of flame due to a draft or other adverse condition. This

feature is provided only as a convenience.

Check Operation of Surface Burners

Push in and turn the surface burners control knobs to light.

The surface burner flame should light within 4 seconds. The first

time a surface burner is lit, it may take longer that 4 seconds to

light because of air in the gas line.

Check the flame on “HIGH” for a blue color. It should be clean

and soft in character. No yellow tip, blowing or lifting of flame

should occur. Occasional orange flashes are normal and reflect

different elements in the air or gas.

A. Manifold entrance

B. Gas pressure regulator

C. Use pipe-joint compound.

D. Adapter (must have ½" male pipe thread)

E. Flexible connector

F. A d ap t e r

G. Use pipe-joint compound.

H. Manual gas shutoff valve

I. ½" or ¾" gas pipe

A. Access cap

B. Rear of cooktop

C. Gas pressure regulator

D. Up arrow. Regulator must be installed with

arrow pointing up to cooktop bottom.

A. Closed valve

B. Open valve

A. Burner cap

B. Burner ports

C. Burner base

D. Gas tube opening

E. Igniter head

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments

KitchenAid KGCD807XBL Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Cookers KitchenAid KGCD807XBL