KitchenAid KHDD2 38510 Instruction for Use download pdf (Page 12)

Note: Refer to the table on page 6 to ensure the correct

type of injector is to be fitted.

Traditional burners (T)

1. Remove the cap (A).

2. Remove the spreader (B).

3. Unscrew the injector (C) with a box spanner 7.

4. Replace the injector with the one for the new gas.

5. Put back burners and pan supports.

Note: Before installing the hob, please remember to stick

the gas calibtration label, provided with the replacement

injectors over the gas information on the underside of the

hob.

Replacing the injectors

Regulating the minimum flow level must be done with the tap at the

lowest position (small flame) .

There is no need to regulate the primary air in the burners.

To ensure the minimum level is properly regulated, remove the control

knob and adjust the screws found on the tap as follows:

1. tighten to reduce the height of the flame 1 (-)

2. slacken to increase the height of the flame (+);

3. With the burners on, rotate the buttons from the maximum to

the minimum position to check the stability of the flame.

Regulating the minimum flow level of the gas taps

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

KitchenAid KHDD2 38510 Instruction for Use Page 12