Instructions for useGBIT
10The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage a
11Note: Refer to the table on page 6 to ensure the correcttype of injector is to be fitted.Traditional burners (T)1. Remove the cap (A).2. Remove the
12Regulating the minimum flow level must be done with the tap at thelowest position (small flame) .There is no need to regulate the primary air in the
13Before any cleaning and/or maintenanceoperation, disconnect the hob from powersupply and wait until it is cold.To keep the hob in perfect condition,
14If the hob is not working properly work throughthe this guide before contacting our CustomerCare Centre.The burner does not ignite, or the flame isu
Whirlpool EMEA S.p.A. Via Carlo Pisacane n.1,20016 Pero (MI), Italywww.whirlpool.euPrinted in Italyr 10/16400010902550
Product description and symbols 4Using the burners 4Practical advice on using the hob 5Positioning the pan supports and wok support (also as spacer) 5
41. Removable pan supports2. Semi-rapid burner3. Semi-rapid burner4. Rapid burner5. Auxiliary burner6. Professional wok burner7. Semi-rapid burner con
5Read the instructions to get the best out of yourhob.- Use pans with a similar diameter to the burner(see the table on this page)- Use flat bottomed
6771+10490+10750+10511+10R 121.5If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correctheight ab
7To get the most out of your hob, please readthe instructions carefully and keep them forfuture consultation.• These instructions are only valid in t
8PackingThe packing material is 100% recyclable and islabelled with the recycling symbol . Pleasedispose of all packing responsibly and carefully.Pro
9Technical information for the installer• This appliance can be built into a 30mm to70mm thick worktop.• If no oven is to be installed below the hob
Comments to this Manuals