Installation Instructions Kl+chenAtd l FOR THE WAY IT’S MADE: changing the Bin Door and lower Panels . . . . . . . . . . . . . . . 2 Thermostat cal
H ow the Ice Maker Works l Compressor runs l Condenser fan runs l Water pump runs (circulates water) l Cutter grid is warm to touch
21 nit Wiring Diagrams This model operates at 115 volts except for the cutter grid circuit which operates at 8.5 volts at 1 amp. The
Part No. 2175675 cb 1994 KlkhenAld QD RegIstered Trademark /TM Trademark 01 KItchenAM. Printed in U.S.A.
Changing the Bin Door and Lower Panels Ktoor (26; mm) Lower DIMENSIONS The storage bin door is designed to accept an optional decorativ
c hanging the Bin Door and Lower Panels Thermostat calibrations If ice maker is installed more than 2,000 feet (600 m) above sea leve
G eneral Information 1. Lay carton on rear face and break open bottom flaps. 2. Set carton upright with all four flaps outward. 3. L
G eneral Information HEI locate unit 1. Place unit so the front side will be com- pletely unobstructed to provide proper airflow. 2. A
F or the Plumber Connect to water (observe local codes) 1. Use W (6 mm) OD soft copper tubing for the cold water supply. 2. Provide
.~ sr the Plumber m Connect to drain (observe local codes) 1. The unit is provided with a gravity drain. 2. The ideal installation ha
F or the Electrician Electrical requirements A 115 Volt, 60 Hz., AC only, 15 or 20 It is recommended that a separate circuit, ampere
0 perating Instructions l For complete operation information, refer to the Use and Care Guide. l Before starting, wash out interior of
Comments to this Manuals