KitchenAid Freestanding Gas Ranges User Manual download pdf (Page 14)

3. Turn the Number M50 Natural gas broil burner orifice hood

counterclockwise to remove.

4. Install the Number 57 LP gas broil burner orifice hood, turning

it clockwise 4 or 5 turns. Do not overtighten.

5. Place the broil burner on the broil burner orifice hood. Insert

the broil burner locator pin in the hole in the oven back.

6. Position the broil burner against the roof of the oven cavity

and attach with screw.

To Convert Surface Burners

1. If installed, remove the burner grates.

2. Remove the burner caps.

3. Using a Phillips screwdriver, remove the burner base.

4. Apply masking tape to the end of a ⁹⁄₃₂" (7.0 mm) nut driver to

help hold the Natural gas orifice spud in the nut driver while

changing it. Press nut driver down onto the Natural gas orifice

spud and remove by turning it counterclockwise and lifting

out. Set the Natural gas orifice spud aside.

Use the following chart for correct LP gas orifice spud for each

burner. Refer to the rating plate on the lower right side of the front

frame for proper sizing of LP gas orifice spuds for each burner

location.

LP Gas Orifice Spud Chart

5. Replace the Natural gas orifice spud with the correct LP gas

orifice spud. See the “LP Gas Orifice Spud/Hood Chart.”

6. Replace burner base and hand tighten the screws.

7. Replace burner cap.

8. Repeat steps 1 through 7 for the remaining burners.

9. Place Natural gas orifice spuds in plastic parts bag for future

use and keep with package containing literature.

10. Replace burner grates.

11. Reinstall storage drawer. See the “Replace Oven Racks and

Storage Drawer” section for instructions.

12. Reinstall oven door. See the “Oven Door” section in the Use

and Care Guide.

13. Complete installation. See “Make Gas Connection” and

“Electronic Ignition System” sections.

Checking for proper cooktop burner flame is very important.

The small inner cone should have a very distinct blue flame

¼" to ½" long. The outer cone is not as distinct as the inner

cone. LP gas flames have a slightly yellow tip.

IMPORTANT: You may have to adjust the “LO” setting for

each cooktop burner.

A. Number M50 Natural gas broil burner orifice hood

A. Number 57 LP gas broil burner orifice hood

A. Broil burner orifice hood

B. Broil burner

C. Broil burner locator pin

D. Broil burner locator hole

A. Burner cap

B. Gas tube opening

C. Burner base screws

D. Burner base

A. Natural gas orifice spud

Burner Rating Color Number

4,000 BTU Blue 64L

9,100 BTU Clear 91L

10,500 BTU Green 97L

14,000 BTU Red 114L

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments

KitchenAid Freestanding Gas Ranges User Manual Page 14

Comments to this Manuals

Related products and manuals for Cookers KitchenAid Freestanding Gas Ranges