KitchenAid KGCU467VSS Instruction Manual download pdf (Page 12)

Complete Installation

Install Burner Bases and Burner Caps

Install the burner base, making sure the igniter electrode is

properly aligned with the base. Place burner caps on top of

burner bases. If burner caps are not properly positioned, surface

burners will not light.

Electronic Ignition System

Initial lighting and gas flame adjustments

Cooktop burners use electronic igniters in place of standing

pilots. When the cooktop control knob is turned to any position,

the system creates a spark to light the burner. This sparking

continues, until the flame is lit or the knob is turned to Off.

Check Operation of Cooktop Burners

Push in and turn each control knob to the “LITE” position.

The surface burners and grill flames should light within

4 seconds. The first time a burner is lit it may take longer than

4 seconds to light because of air in the gas line.

After verifying the proper burner operation, turn the control knobs

to OFF.

If burners do not light properly:

■ Turn cooktop control knob to the “OFF” position.

■ Check that the cooktop is plugged in and the circuit breaker

has not tripped or the fuse has not blown.

■ Check that the gas shutoff valves are set to the “open”

position.

■ Check that burner caps are properly positioned on burner

bases.

Repeat start-up. If a burner does not light at this point, contact

your dealer or authorized service company for assistance.

If you need Assistance or Service:

Please reference the “Assistance or Service” section of the Use

and Care Guide or contact the dealer from whom you purchased

your cooktop.

Flame Height

The cooktop flame should be a steady blue flame approximately

¼" (0.64 cm) high.

Dual Flame Burner

Single Flame Burner

To Adjust Flame Height:

1. Unplug cooktop or disconnect power.

2. Remove burner grates.

3. Remove the control knobs.

4. Pull cooktop forward to expose the control console screws

on the side of the cooktop burner base.

5. Remove the 2 screws on each side of the cooktop burner

base that hold the control console in place.

6. Disconnect wiring from the control console.

On Grill Models:

Support the control console in the middle with one arm and

disconnect the grill indicator light with the other hand.

20,000 Btu/h Ultra Power™ Dual-Flame Burner

A. Incorrect

B. Correct

15,000 Btu/h Professional Burner

A. Incorrect

B. Correct

5,000 Btu/h Simmer/Melt Burner

A. Incorrect

B. Correct

A. Upper (simmer) flame

B. Lower flame

A. Console attachment screws

A. Grill indicator light connector

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments

KitchenAid KGCU467VSS Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Cookers KitchenAid KGCU467VSS