KitchenAid KHMP5 77510 Instruction for Use download pdf (Page 11)

Note: Refer to the table on page 6 to ensure that the

correct type of injector is fitted.

Traditional burners (T)

1. Remove the cap (A).

2. Remove the burner ring (B).

3. Unscrew the injector (C) using a 7 mm hex key.

4. Replace the injector with one for the new type of gas.

5. Refit the burners and the pan supports.

Note: Before installing the hob, remember to stick the gas

calibration label provided with the replacement injectors

over the current information on the underside of the hob.

If you are using a different type of gas from the

one indicated on the rating plate and the orange

label on the back of the hob, you will need to

replace the injectors and adjust the primary air for

the wok burner (see injector table on page 6).

The orange label should be removed and kept

together with the manual.

Use pressure regulators that are suitable for

the gas pressures indicated on page 6

• To replace the injectors, contact our Customer

Care Centre on 00800-3810-4026 or a qualified

electrician.

• Injectors not supplied as standard must be

requested from our Customer Care Centre on

00800-3810-4026.

• Regulate the minimum levels of the taps.

Note: When using liquefied petroleum gas

(G30/G31), the bypass screw must be screwed

in fully. If you then have difficulty turning the

control knobs, contact our After-sales Service

though our Customer Care Centre on

00800-3810-4026 – they will arrange for a

replacement after ascertaining that the tap is

damaged.

Replacing the injectors

Conversion to a different type of gas supply

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

KitchenAid KHMP5 77510 Instruction for Use Page 11