Technical information for the installer
• This appliance can be built into a worktop that
is 20–40 mm thick.
• If an oven is not being installed below the hob,
a panel must be fitted underneath the hob to
prevent damage to it and protect the contents
of the cupboard. This panel must cover the
entire underside of the hob and must be
positioned so that it is at least 20 mm away
from the underside of the hob and no more
than 150 mm away from the underside of the
worktop.
• This hob is designed to work perfectly with
any oven in the KitchenAid range. The
manufacturer cannot be held liable if any
other make of oven is installed.
The manufacturer cannot be held liable if
any other make of oven is installed.
Before installing the appliance, please ensure
that:
• Warning: This is a heavy product and we
therefore recommend that it is installed by
two people.
• The gas supply (type and pressure) and hob
calibration are compatible (see rating plate on
hob and table on page 6).
• The cabinets and appliances in the vicinity of
the hob are heat resistant and comply with
local regulations.
• Combustion fumes are removed from the air in
the room by an extractor hood or an electric
fan installed on a wall and/or windows in
accordance with current regulations.
• Air can circulate naturally through a suitable
opening that is no less than 100 cm
2
in cross
section. This must:
- Be permanent and accessible on a wall of the
room being ventilated; it must draw air
outside.
- Be created in such a way that it cannot be
accidentally obstructed either from the inside
or the outside.
- Be protected by plastic grille or metal grid,
etc. that does not reduce the 100 cm
2
cross
section.
- Be located in a place that does not interfere
with the extraction of combustion fumes.
9
WARNING: This work must be performed by a qualified
technician.
• The gas supply system must comply with local regulations.
• You can find specific local regulations for some countries in the
section entitled "Reference to local regulations". If no
information about your country is provided, please ask your
installer for details.
• The hob must be connected to the gas supply system or gas
cylinder either using a rigid, jointed copper or steel pipe that
complies with local regulations or using a flexible, seamless
stainless-steel pipe that complies with local regulations. The
maximum length of the pipe is two linear metres.
• Connect the elbow (A)* or (B)* provided to the main supply pipe
for the hob and fit the washer (C) provided in accordance with
EN 549.
* Use elbow (A) for France and elbow (B) for all other countries.
IMPORTANT: If using a stainless-steel pipe, it must be installed
in such a way that it cannot touch any moving part of the
cabinet. It must pass through an area where there are no
obstructions and where it can be inspected across its entire
length.
• After connecting the appliance to the gas supply, check for leaks
using soapy water. With the burners on, turn the control knobs
from the maximum to the minimum position to check the
stability of the flame.
Gas connection
Installation
(16 pages)
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals