KitchenAid KHPF 7520/I Instruction for Use download pdf (Page 10)

The electrical connections must comply with current

legislation and be carried out by a qualified, competent

person.

• Information on the voltage and power absorbed are shown

on the serial no. plate.

• The appliance must be earthed.

• When installing the appliance, we recommend that this hob

is protected by a 3mm bi-polar switch.

• If damaged, the power cable must be replaced with an

identical type of powercable ( H05V2V2-FT90ºC, or

H05RR-F type). We recommend that this operation be

conducted by our After Sales Service. Please contact our

Customer Care Centre on 00800-3810-4026.

• Do not use extension cables.

• The manufacturer declines all responsibility for damage to

persons, pets or goods as a result of failure to comply with

the regulations above.

Electrical connection

Earth

(yellow/green)

Important: The following procedure shall be carried out by

competent technical personnel only. The hob can be installed

on different types of materials, such as masonry, metal, bare

wood and heat resistant laminate coated wood (90°C).

Cut an opening in the worktop to the dimensions shown in the

diagram.

Carefully place the seal on the external outline of the worktop, as

shown in the figure below. Apply a light hand pressure to ensure a

good adhesion to the surface.

Fix the hob to the unit, using the fixing brackets provided.

Note: the electrical power cable must be long enough to allow the

hob to be lifted out from above.

Fixing the Hob to the supporting structure. Traditionally fitted

model (Semi Flush fitting).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

KitchenAid KHPF 7520/I Instruction for Use Page 10