KitchenAid KHPF 7520/I Instruction for Use download pdf (Page 11)

Important: The following procedure shall

be carried out by competent technical

personnel only. The hob can be installed

on different types of materials, such as

masonry, metal, bare wood and heat

resistant laminate coated wood (90°C).

Cut an opening into the worktop to the

dimensions shown in the diagram. In order to

correctly fit this type of hob, a 3mm deep

recess around the edge of the opening is also

needed.

Note: In case of laminated worktops with a laminate thickness lower

than 3 mm, create a recess as shown as on the detailed schematic

drawing.

Before positioning the hob, apply the adhesive seal supplied on the

bottom perimeter of the hob itself, where this will be in contact with

the worktop (fig. 2).

Once the seal is in position, place the hob in the recess. Fix the hob

to the worktop using the screws and brackets provided, tightening

them carefully until the hob is perfectly flush. (fig. 3).

Carefully trim the excess seal. In case of installation on wood

(particularly chipboard), any small spaces between the edge of the

recess and the outside edge of the hob should be filled with small

quantities of silicon sealant (see fig. 4). Once the appliance has been

installed, the bottom part of the hob should be completely accessible.

Important:

• tighten the fixing brackets of the hob to the work top by hand,

using minimum force.

• In case of wooden (or similar) worktops, before fitting the

adhesive seal protect the surface of the milled recess with a

primer.

Slots for extra brackets have been created on the bottom of the

appliance, to help achieve a more flush positioning (should this be

necessary). Appropriate brackets can be obtained from the Customer

Care Centre.

Fixing the Hob to the worktop. Flush fitted model.

R.10

Fig. 1

Fig. 2

Fig. 3

Fig. 4

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

KitchenAid KHPF 7520/I Instruction for Use Page 11