KitchenAid KCVWX 20600L Installation Manual download pdf (Page 8)

Transport to installation site and unpacking

Since this is a large and heavy appliance, before transporting the appliance, check the access to the location

where it will be installed (door size, manoeuvring space in stairwells, etc.).

The appliance is attached to the base of the packaging (pallet) through four bolts which can be removed

using a 17 mm (3/4” in) wrench.

It is recommended to use a manual transporting device to move the appliance to the installation site, and

only at this point to remove the base of the packaging.

The appliance should always be transported in an erect position.

If this is not possible, transport the appliance laying on its rear side.

Once at the installation site, the appliance, which is equipped with four wheels, can be taken off the pallet

and positioned in the installation area.

Operate as follows:

•

Take off the four bolts 1 securing the appliance to the

pallet by means of a 17 mm (3/4” in) open spanner.

Remove the fixing brackets 3 and 4.

•

To remove the front fixing bracket 3, unscrew for one

or two turns the rear wheel adjusting bolt 2 by means

of a 13 mm (1/2” in) box spanner, avoiding too much

strenght while thightening the nut, which could

damage the leveling feet adjusting system.

•

From the back of the unit and by means of a suitable,

high duty hand trolley, take off the appliance and

place it on the floor.

Be very careful to avoid any damage to floors.

Delicate floors should be protected with plywood, hard

cardboard or similar material panels.

Theapplianceisveryheavy.

Takemaximumcareduringhandlingtoavoidinjury.

Theapplianceshouldalwaysbetransportedinanerectposition.

Avoidatallcostsleaningitonitsfrontside.

Preparing the installation

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

KitchenAid KCVWX 20600L Installation Manual Page 8