KitchenAid KBBL206ESS Installation Guide download pdf (Page 13)

Stainless Steel and Overlay Series

Factory Panels and Kits

(36" [91.4 cm] Models)

All factory parts are available through your KitchenAid dealer or by

calling KitchenAid Parts and Accessories at 1-800-442-9991. In

Canada, call 1-800-807-6777.

Stainless Steel Series 72" (183 cm) Top Grille Panel Kit

A 72" (183 cm) wide Top Grille Panel Kit is available. This kit allows

2 units (one left-hand swing and one right-hand) to be installed

side by side with a single grille.

Extended Door Handle Kits

Use extended door handles when additional finger clearance is

needed between the door handles and custom panel. Follow the

kit instructions for installing the door handles.

Stainless Steel

Series Custom Side Panels

Custom side panels may be needed when not enough space is

available to have cabinets on both sides of the refrigerator or

when the refrigerator is placed at the end of a cabinet run. You

may choose an Inset, Flush, or Recessed Inset panel installation.

Refrigerator and Side Trim Dimensions

The width and height of a side panel are determined by the type of

installation you are planning.

NOTES:

■ The dimensions shown are actual product dimensions and

may not reflect the needed panel installation dimensions.

■ The side panel should be a minimum of ¹⁄₂" (1.27 cm) thick

to avoid warping.

■ If the opening depth is 25" (63.5 cm) or more, you may

want to install a support board on the rear wall.

Refrigerator

Side Trim

Inset Installation Dimensions

1. Measure the distance from point A (as shown) to the back

wall. Add ⁷⁄₃₂" (5.6 mm) to this measurement to allow the side

panel to fit into the trim.

2. If the panel is more than ¹⁄₄" (6.35 mm) thick, rout the front

edge to allow the side panel to fit into the trim.

Flush Installation Dimensions

1. Measure the distance from point A (as shown) to the back

wall.

2. Attach the support board with a screw or adhesive that is

compatible with aluminum and wood.

Recessed Inset Installation Dimensions

1. Measure the distance from point A (as shown) to back wall.

2. Rout the front edge of the support board or attach a ¹⁄₄"

(6.35 mm) board to hold the panel in the cabinet side trim.

Stainless Steel (Stainless Steel Series) #W10153554

Matte Aluminum (Overlay Series) #4396718

24¹⁄₈"

(61.3 cm)

¹⁄₂"

(59.7 cm)

23¹¹⁄₁₆"

(60.3 cm)

⁹⁄₁₆"

(13.9 mm)

¹⁄₂"

(12.2 mm)

¹¹⁄₁₆"

(18.0 mm)

⁵⁄₈"

(15.7 mm)

1 ... 12 13 14 ... 72

Comments to this Manuals

No comments

KitchenAid KBBL206ESS Installation Guide Page 13

Comments to this Manuals

Related products and manuals for Fridges KitchenAid KBBL206ESS