KitchenAid KBBL206ESS Installation Guide download pdf (Page 21)

3. Remove one end cap by loosening the nuts and sliding the

end cap off.

4. Slide the custom panel into the top grille channel and reattach

the end cap.

5. Replace the top grille in the cabinet side trims and pull the

panel down slightly to lock it into place.

Adjust Door(s)

Door Alignment (36" [91.4 cm] Single-Door Models)

1. Loosen, but do not remove, the four Torx

®†

27 flat-head

mounting screws and the two ¹⁄₄" hex-head mounting screws

in the top hinge.

2. Adjust the top hinge of the door to align it.

3. Tighten the Torx

®†

27 flat-head mounting screws to a torque of

approximately 100 inch-pounds (11.3 Nm).

4. Tighten the ¹⁄₄" hex-head screws.

Door Height Adjustment (36" [91.4 cm] and 42"

[106.7 cm] French Door Models)

Use the following steps to adjust the door height, up or down,

after the refrigerator has been leveled.

NOTE: Adjust the right-hand door to the position of the left-hand

door first. If it is necessary to adjust the left-hand door, you must

make sure that the hinged center rail located on the left-hand door

does not drag when closing the door.

1. Open the freezer drawer. Remove the locking plate screw from

the bottom side of the refrigerator door hinge using a

¹⁄₄" open-end wrench.

2. Remove the locking plate as shown.

3. Turn the bushing located underneath the bottom of the hinge

using a ¹⁄₂" open-end wrench. Turning the bushing to the left

will lower the door. Turning the bushing right will raise the

door.

4. After adjusting, check the doors to make sure they are even at

the top and bottom. If the doors are not even, continue to turn

the bushing to adjust the door.

5. Replace the locking plate.

■ Turn the bushing slightly to align the hinge and locking

plate screw holes.

■ Replace and tighten the locking plate screw.

6. Make final check to make sure the doors are aligned and

even.

A. Bottom rail

B. Nuts

C. End cap

D. Top rail

A. Custom panel

A. Top grille

B. Cabinet side trims

B BA

†®TORX is a registered trademark of Saturn Fasteners, Inc.

A. Torx

®†

27 flat-head mounting screws

¹⁄₄

" hex-head mounting screws

A. Bushing

B. Locking plate

C. Locking plate screw

BCA

1 ... 20 21 22 ... 72

Comments to this Manuals

No comments

KitchenAid KBBL206ESS Installation Guide Page 21

Comments to this Manuals

Related products and manuals for Fridges KitchenAid KBBL206ESS